English
简体中文The key component of the rotary dehumidifier is a honeycomb-shaped shaft, which is made of nylon fiber media and active silica gel materials; both sides of the shaft are divided into two areas by specially made sealing equipment: the solution area and the reconstruction area; When the wet and cold air enters the solution area of the shaft, the saturated water vapor is absorbed by the active silica gel material of the shaft, and the dry gas is sent to the space that must be disposed by the solution centrifugal fan; while the continuously rotating shaft carries the saturated gas Water vapor enters the reconstruction area; the high-temperature gas blown in the opposite direction in the reconstruction area promotes the moisture in the shaft to be absorbed, and is discharged by the centrifugal fan, so that the shaft restores its hygroscopicity and performs the regeneration process. The shaft rotates continuously, the above Dehumidification and regeneration are carried out repeatedly, thus ensuring a stable dehumidification state of the rotary dehumidifier.
ZCS-Series Low Dew Point Glove Box Dehumidifiers
ZCS-Series Low Dew Point Glove Box Dehumidifiers
Applications:
Specifically designed for ultra-low dew point filling glove boxes in lithium battery or small drying rooms.
Features:
1. Programmable controller with HMI，easy to operation.
2. The reactivation temperature adopts optional P.I.D. control, and it has over-temperature and over-limit protection and alarm system.
3. Regular operation and time delay protection function significantly improves the rotor's life.
4. With P.I.D. controlled reactivation temperature, supplied dry air able to precisely control depend on actual dehumidification condition, which possess remarkable energy saving effect.
5. Programmable controller displays each spot parameter and has automatic diagnosis function.
6. With full return air type and full fresh air type depends on different use of the glove box.
Moisture in the air is absorbed by the water-absorbing properties of the microporous plate of the silica gel material, and the solidification of the structure in the microporous plate will also absorb a lot of water. The heated gas enters the regeneration zone to raise its temperature, the moisture adsorbed in the microporous plate is activated, the adsorption capacity is weakened, and the moisture is discharged from the silica gel material microporous plate.
The Rotary Dehumidification Unit adopts the imported high-efficiency shaft; the rotor adopts the patented invention, with an organic binder, the nylon fiber is processed into a honeycomb shape, and any organic chemical substances are migrated under high temperature ignition, and then the honeycomb base material The shaft is combined with the unique silica gel material (metal silicate material) through polycondensation reaction, so it not only has good heat resistance, but also can be used under any ambient humidity; it has strong dehumidification ability, no desiccant outflow, and does not contain Toxic, non-corrosive, ensuring long-term reliable and stable operation; because the shaft improves water absorption and the microporous plate absorbs a large amount of water, according to gas standards, the drying capacity is 20% to 30% higher than that of other silica gel material shafts.
The carbon molecular sieve shaft of the rotary dehumidifier uses activated carbon as a dehumidifier embedded in the nylon fiber substrate. Because the activated carbon has small porosity and strong heat resistance, this shaft is suitable for low leakage conditions, or used for Solve the gas with volatile organic substances such as ethylene glycol, acetaldehyde, etc.; the regenerated gas up to 220 ℃ can be used for the shaft, and it is basically impossible for the entire shaft to produce polycondensation reaction; this shaft is produced by unique activated carbon according to unique chemical changes The crystal is grown on nylon fiber, and according to the cyclone condition, a single shaft can achieve -80°C D.P.
